LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Crosstrek Limited >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior/Interior Trim >> Exterior Trim & Interior Trim >> Glove Box >> Removal >> IMPREZA Model

IMPREZA Model

NOTE: Refer to "Security and Locks" information for key cylinder replacement. Ref. to SECURITY AND LOCKS>KEY LOCK CYLINDERS>REPLACEMENT>GLOVE BOX LID .
  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the pocket assembly.
    1. Remove the damper COMPL - pocket.
    2. Release the stoppers and remove the pocket assembly by pulling it toward you.
    G11246529Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the back panel - pocket.
    1. Release the clips, and remove the under cover assembly - passenger.
      G11246530Courtesy of SUBARU OF AMERICA, INC.
    2. Remove the clips, and remove the cover - instrument panel side RH.
      G12399277Courtesy of SUBARU OF AMERICA, INC.
      NOTE:
      • Use a plastic remover.
      • If removing is difficult, remove the weather strip, then remove the part from the gap using a plastic remover.
    3. Release the clips, and remove the ornament panel - passenger.
      G12399273Courtesy of SUBARU OF AMERICA, INC.
    4. Remove the glove box light LED, and disconnect the connector.
    5. Release the claws and remove the screws, then remove the back panel - pocket.
      G13607035Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals