DTC B2B03: Driver's Door Power Window Pulse1 And 2 No Signal

DTC detecting condition: 

When all the following conditions are established.

1. When sensing areas are recognized.
2. When no-pulse-input state continues in both pulse 1 and 2 phases.
3. When "absolute value judgment" is detected during UP operation.
4. After the condition 3 is met, when motor lock (no-pulse-input state in both pulses 1 and 2 phases for 300±10 milliseconds) is detected during reverse operation.

Trouble symptom: 

When the power window main switch is operated, driver's side window rolls down only in manual down operation, or inches up. (Inch up: Operating the switch rolls up the window about 10 mm only)

1. SYSTEM INITIALIZATION  .
   1. Turn the ignition switch to ON.
   2. Using the Subaru Select Monitor, perform [System Initialization] of [Power Window (Driver)]. Ref. to POWER WINDOW (DIAGNOSTICS)>WORK SUPPORT>OPERATION>SYSTEM INITIALIZATION .
      NOTE: Record the DTCs and FFD because they will be erased when the initialization is performed.
   3. Perform the initial setting of the power window. Ref. to GLASS/WINDOW/MIRRORS>POWER WINDOW SYSTEM>OPERATION .
   4. Operate the power window main switch and check that the power window (driver's side) operates.

   Does the power window operate normally according to switch operation?

   Yes:  Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

   NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

   No:  Go to  2.

2. CHECK DTC  .

   Read the DTC of [Power Window (Driver)] using the Subaru Select Monitor. Ref. to POWER WINDOW (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .

   Is DTC B2B03 displayed? (Current malfunction)

   Yes:  Replace the front regulator and motor assembly (driver's side). Ref. to GLASS/WINDOW/MIRRORS>FRONT REGULATOR AND MOTOR ASSEMBLY .

   No:  Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

   NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.