Rear Quarter Glass: Removal
- Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY
.NOTE: For the hybrid model, disconnect the battery negative terminal.
- Remove the trim panel - rear pillar UPR. Ref. to EXTERIOR/INTERIOR TRIM>REAR QUARTER TRIM>REMOVAL .
- Remove the glass - rear quarter in the same procedure as for the glass - front window. Ref. to GLASS/WINDOW/MIRRORS>WINDSHIELD GLASS>REMOVAL .CAUTION:
- When removing with a windshield glass knife, for the front portion, insert the windshield glass knife from the outside of the compartment, and for the other portions, insert from the inside of the compartment.
- Hold the glass - rear quarter to prevent it from falling down.
- If the glass is reused, be careful not to scrape the adhesive surface of the locating pin.
- If the glass is reused, do not remove the molding - rear quarter lower. If removed, replace with a new glass.
- Remove the locating pin. (When reusing the glass)