Meter Pointer Indication Check

In meter pointer indication check, the meter operation, warning/indicator light and LCD/TFT are checked.

NOTE: ILL indication illuminates at the same brightness as immediately before entering "Meter pointer indication check".

Press the trip reset switch.

After a buzzer sounds for 0.5 seconds and "STEP2" is displayed on LCD/TFT, the meter pointer indication check mode is initiated.

Except for hybrid

Time (sec)

Speedometer (km/h)

Tachometer (r/min)

ECO gauge

Warning light/indicator light

1.5

Lowest point

The following lights are lit.⁽¹⁾

Engine coolant temperature indicator light (blue)
Fuel level warning light (near the E mark)⁽²⁾

1.5

-Max

1.5

1, 000

1.5

100

4, 000

+ Max

1.5

1, 000

1.5

-Max

⁽¹⁾	Warning lights and indicator lights controlled by other module are turned on/off according to the module control. Ref. to INSTRUMENTATION/DRIVER INFO>GENERAL DESCRIPTION>SPECIFICATION .

⁽²⁾	Model with normal meter

Hybrid

Time (sec)

Speedometer (km/h)

Power meter

Warning light/indicator light

1.5

Vehicle stop position

The following lights are lit.⁽¹⁾

Engine coolant temperature indicator light (blue)

1.5

Vehicle stop position

1.5

Vehicle stop position

1.5

100

Vehicle stop position

1.5

Vehicle stop position

1.5

Vehicle stop position

⁽¹⁾	Warning lights and indicator lights controlled by other module are turned on/off according to the module control. Ref. to INSTRUMENTATION/DRIVER INFO>GENERAL DESCRIPTION>SPECIFICATION .