Related Lines, More Than 52 Ω And Less Than 62 Ω (Steering Angle Sensor)

Wiring diagram: 

CAN communication system Ref. to WIRING SYSTEM (IMPREZA MODEL)>CAN COMMUNICATION SYSTEM>WIRING DIAGRAM . Ref. to WIRING SYSTEM (CROSSTREK MODEL (EXCEPT FOR HEV))>CAN COMMUNICATION SYSTEM>WIRING DIAGRAM .

• Impreza model

  Courtesy of SUBARU OF AMERICA, INC.

  Courtesy of SUBARU OF AMERICA, INC.

• Crosstrek model

Courtesy of SUBARU OF AMERICA, INC.

Courtesy of SUBARU OF AMERICA, INC.

1. CHECK BETWEEN RELATED LINES AND MAIN WIRING HARNESS  .
   1. Disconnect the steering angle sensor connector.
   2. Using a tester, measure the resistance between terminals of steering angle sensor connector.

      Connector and terminal 

      (i74) No. 2 - (i74) No. 3:

   Is the resistance 400 Ω or more?

   Yes:  A related line between steering angle sensor and main wiring harness is open, or main wiring harness is open at two places or more.

   No:  Go to  2.

2. CHECK RELATED LINES  .
   1. Disconnect the body integrated unit connector.
   2. Using a tester, measure the resistance between steering angle sensor connector and body integrated unit.

      Connector and terminal 

      (i74) No. 2 - (i171) No. 2:

      (i74) No. 3 - (i171) No. 1:

   Is the resistance 10 Ω or more?

   Yes:  Repair or replace the open circuit of steering angle sensor related lines.

   No:  Check DTC of VDC control module. Ref. to BRAKE CONTROL (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .