Switches and Harness: Removal

BSD/RCTA OFF switch

1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
   NOTE: For the hybrid model, disconnect the battery negative terminal.
2. Remove the cover assembly - instrument panel LWR driver OUT. Ref. to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL LOWER COVER>REMOVAL .
3. Remove the BSD/RCTA OFF switch.
   1. Release the claws and remove the BSD/RCTA OFF switch.

      Courtesy of SUBARU OF AMERICA, INC.