Switches and Harness: Inspection

BSD/RCTA OFF switch

1. Measure the resistance between connector terminals.

   Preparation tool:  Circuit tester

   Courtesy of SUBARU OF AMERICA, INC.

   Terminal No.	Inspection conditions	Standard
   6 - 8	Switch OFF	1 MΩ or more
   	Switch ON	Less than 1 Ω

2. Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.
   CAUTION: When applying battery voltage, do not mix up the positive (+) side and the negative (-) side.
   Incorrect polarity connection may cause LED damage inside the switch.

   Terminal No.	Inspection conditions	Specification
   1 (+) - 4 (-)	Apply battery voltage.	Light ON

3. Replace the BSD/RCTA OFF switch if it is found defective.