DTC B14A3: Refrigerant Pressure Sensor Circuit Open

DTC detecting condition: 

Refrigerant pressure sensor circuit is open.

Trouble symptom: 

Compressor does not operate.

Wiring diagram: 

Air conditioning system Ref. to WIRING SYSTEM (CROSSTREK MODEL (HEV))>AIR CONDITIONING SYSTEM>WIRING DIAGRAM .

Courtesy of SUBARU OF AMERICA, INC.

1. CHECK CONNECTOR  .
   1. Check connecting condition of the A/C control panel connector, pressure sensor connector and coupling connector.
   2. Turn the ignition switch to ON.
   3. Read the DTC of [Air Conditioner] using the Subaru Select Monitor. Ref. to AIR CONDITIONER (DIAGNOSTICS) (HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .

   Is DTC B14A3 displayed? (Current malfunction)

   Yes:  Go to  2.

   No:  Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

   NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
2. CHECK PRESSURE SENSOR  .
   1. Turn the ignition switch to OFF.
   2. Disconnect the pressure sensor.
   3. Short No. 1 and No. 2 of connector B505.
   4. Turn the ignition switch to ON.
   5. Read the DTC of [Air Conditioner] using the Subaru Select Monitor. Ref. to AIR CONDITIONER (DIAGNOSTICS) (HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .

   Is DTC B14A4 displayed? (Current malfunction)

   Yes:  Replace the pressure sensor. Ref. to AIR CONDITIONER (HEV)>PRESSURE SENSOR .

   No:  Go to  3.

3. CHECK HARNESS  .
   1. Turn the ignition switch to OFF.
   2. Restore the temporary shorted lines made in step 2.
   3. Turn the ignition switch to ON.
   4. Using a tester, measure the voltage between pressure sensor connector terminals.

      Connector and terminal 

      (B505) No. 3 (+) - (B505) No. 1 (-):

   Is the voltage 4.5 - 5.5 V?

   Yes:  Go to  4.

   No:  Repair or replace the open circuit of harness.

4. CHECK HARNESS (OPEN CIRCUIT)  .
   1. Turn the ignition switch to OFF.
   2. Disconnect the connector from the A/C control panel.
   3. Using a tester, check the continuity between A/C control panel connector and pressure sensor connector terminals.

      Connector and terminal 

      (B505) No. 1 - (i181) No. 19:

      (B505) No. 2 - (i181) No. 8:

      (B505) No. 3 - (i181) No. 7:

   Is there continuity?

   Yes:  Replace the A/C control panel. Ref. to AIR CONDITIONER (HEV)>CONTROL PANEL .

   No:  Repair or replace the open circuit of harness.