LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Crosstrek Hybrid >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> HVAC System (Heater, Ventilator And A/C) (HEV) >> Mode Door Actuator >> Installation

Mode Door Actuator: Installation

  1. When replacing the link - mode with a new part, apply a thin coat of grease evenly to the contact area inside the rail of link - mode by using approx. 5 mm (0.2 in) width and approx. 0.1 g (0.004 oz) of grease squeezed out from a tube.
    NOTE: After installing the actuator, perform 3 - 5 times of adaptation for the grease to fit in.

    Preparation items:  Genuine part: SUBARU genuine grease (72129AJ000)

  2. Install the motor - actuator mode.
  3. Install the heat pump control module. Ref. to AIR CONDITIONER (HEV)>CONTROL UNIT>INSTALLATION .
  4. Install the pocket assembly and the back panel - pocket. Ref. to EXTERIOR/INTERIOR TRIM>GLOVE BOX>INSTALLATION .
  5. Connect the battery ground terminal. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About LEMON Manuals