| Circuit tester |
Used for measuring resistance and voltage. |
| DST-i |
Used together with Subaru Select Monitor 4. |
| Clip remover |
Used for removing clips. |
Wrench
Courtesy of SUBARU OF AMERICA, INC.
|
Various wrenches
will be required to service any A/C system. 7 - 40 N.m (0.7 - 4.1 kgf-m, 5 - 30 ft-lb) torque wrench and various crowfoot wrenches will be needed. Open end or flare nut wrenches will be needed to affix the pipe and hose fittings. |
Applicator bottle
Courtesy of SUBARU OF AMERICA, INC.
|
A small applicator bottle
is recommended to apply compressor oil to the various parts. It can be available at a hardware store. |
Manifold gauge set
Courtesy of SUBARU OF AMERICA, INC.
|
A manifold gauge set
(with hoses) is available at either a refrigerant supplier or an automotive equipment supplier. |
Refrigerant recovery system
Courtesy of SUBARU OF AMERICA, INC.
|
A refrigerant recovery system
is used for the recovery and recycling of A/C system refrigerant after contaminants and moisture have been removed from the refrigerant. |
Syringe
Courtesy of SUBARU OF AMERICA, INC.
|
A graduated plastic syringe
will be needed to add oil into the system again. A syringe can be available at a pharmacy or drug store. |
Vacuum pump
Courtesy of SUBARU OF AMERICA, INC.
|
A vacuum pump
is necessary (for a good working condition), and may be available at either a refrigerant supplier or an automotive equipment supplier. |
Can tap
Courtesy of SUBARU OF AMERICA, INC.
|
A can tap
for refrigerant cans is available at an automotive equipment supplier. |
Thermometer/hygrometer
Courtesy of SUBARU OF AMERICA, INC.
|
A pocket thermometer/hygrometer
is available at either an industrial hardware store or a refrigerant supplier. |
Electronic leak detector
Courtesy of SUBARU OF AMERICA, INC.
|
An electronic leak detector
is available at either a specialty tool supplier or an A/C equipment supplier. |
Weight scale
Courtesy of SUBARU OF AMERICA, INC.
|
A weight scale
such as an electronic charging scale or a bathroom scale with digital display will be needed, if a 13.6 kg (30 lb) refrigerant container is used. |