Work Support: List

WARNING: This page is about a different variant/trim than selected.

Work Support item	Contents	Reference
ABS Sequence Control Mode	Operate the valve and pump motor continuously to perform the ABS sequence control.	Ref. to VEHICLE DYNAMICS CONTROL (VDC)>ABS SEQUENCE CONTROL .
VDC Function Check Mode	Operate the valve and pump motor continuously to perform the VDC sequence control.	Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC SEQUENCE CONTROL .
Brake Lamp Lighting Operation	Forcibly activate the brake light relay to illuminate the brake light.	Ref. to VEHICLE DYNAMICS CONTROL (VDC)>BRAKE LAMP RELAY>OPERATION>BRAKE LIGHT LIGHTING OPERATION MODE BY SUBARU SELECT MONITOR .
VSC(VDC) Centering Mode	Set the steering angle sensor neutral position, and the lateral G sensor and longitudinal G sensor 0 (zero) point.	Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM AND H/U)>ADJUSTMENT>VDC SENSOR MIDPOINT SETTING MODE .
Reading of parameter: ECM to SSM	Read VDCCM parameter data.	Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM AND H/U)>MAINTENANCE MODE>VDCCM PARAMETER READING .
Writing of parameter: SSM to ECM	Write the parameter data to the VDCCM.	Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM AND H/U)>MAINTENANCE MODE>VDCCM PARAMETER WRITING .
Selection of Parameter	Select and register parameters in the VDCCM.	Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM AND H/U)>MAINTENANCE MODE>VDCCM PARAMETER SELECTION .
Confirm on parameter	Parameters registered in the VDCCM are displayed.	Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM AND H/U)>MAINTENANCE MODE>VDCCM PARAMETER CHECK .