Hill Start Assist Warning Light Does Not Go Off

WARNING: This page is about a different variant/trim than selected.

Detecting condition:

Defective combination meter
Defective CAN communication

Trouble symptom:

Hill start assist warning light does not go off when starting the engine.

CAUTION: Before performing diagnosis, refer to "CAUTION" in "General Description". Ref. to BRAKE CONTROL (DIAGNOSTICS)>GENERAL DESCRIPTION>CAUTION .

CHECK HILL START ASSIST MODE .
Check hill start assist mode.

Is the hill start assist OFF?

Yes: Normal.

No: Go to 2.
READ DTC .
Read the DTC of [Brake Control] using the Subaru Select Monitor. Ref. to BRAKE CONTROL (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .

Is DTC displayed?

Yes: Perform the diagnosis according to the DTC. Ref. to BRAKE CONTROL (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC)>LIST .

No: Go to 3.
CHECK LAN SYSTEM .
Perform the diagnosis for LAN system using the Subaru Select Monitor. Ref. to LAN SYSTEM (DIAGNOSTICS) (EXCEPT FOR HEV)>BASIC DIAGNOSTIC PROCEDURE .

Is DTC of CAN communication displayed?

Yes: Perform the diagnosis according to DTC for LAN system. Ref. to LAN SYSTEM (DIAGNOSTICS) (EXCEPT FOR HEV)>DIAGNOSTIC TROUBLE CODE (DTC)>LIST .

No: Go to 4.
CHECK COMBINATION METER .
Check the combination meter. Ref. to INSTRUMENTATION/DRIVER INFO>COMBINATION METER SYSTEM>OPERATION>SELF-DIAGNOSIS DISPLAY MODE .

Is the check result OK?

Yes: Replace the VDCCM and H/U. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM AND H/U) .

No: Replace the combination meter. Ref. to INSTRUMENTATION/DRIVER INFO>COMBINATION METER .