2.0 L Model

WARNING: This page is about a different variant/trim than selected.

Set a new gasket, install the engine coolant temperature sensor using the ST.
NOTE: STRUT MOUNT SOCKET (20099PA000) can also be used.

Preparation tool:

ST: STRUT MOUNT SOCKET (20399AG000)

Tightening torque:

16 N.m (1.6 kgf-m, 11.8 ft-lb)
Connect the connector to engine coolant temperature sensor.
Install the air intake boot. Ref. to INTAKE (INDUCTION) (H4DO (EXCEPT FOR HEV))>AIR INTAKE BOOT>INSTALLATION .
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
Fill engine coolant. Ref. to COOLING (H4DO (EXCEPT FOR HEV))>ENGINE COOLANT>REPLACEMENT>FILLING OF ENGINE COOLANT .