LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Crosstrek Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Fuel Injection System (Except For HEV)) >> Camshaft Position Sensor >> Installation >> Exhaust Side

Exhaust Side

WARNING: This page is about a different variant/trim than selected.
  1. Install the camshaft position sensor to the chain cover with new O-ring.
    NOTE: Apply engine oil to O-ring.

    Tightening torque: 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

  2. Connect the connectors to camshaft position sensor.
  3. Install the under cover. Ref. to EXTERIOR/INTERIOR TRIM>FRONT UNDER COVER>INSTALLATION .
  4. Lower the vehicle.
  5. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About LEMON Manuals