Brush And Brush Holder
WARNING: This page is about a different variant/trim than selected.
NOTE:
Perform this inspection only for the models without Auto Start Stop.
- Visually check the brush. If there is any abnormal wear or cracks, replace the brush.
- Measure the length of the brush.
Brush length:
Standard
CVT model
12.45 mm (0.490 in)
MT model
12.3 mm (0.484 in)
Limit
CVT model
5.0 mm (0.197 in)
MT model
7.0 mm (0.276 in)
- Check that the brush moves smoothly in the brush holder.
- Measure the brush spring force with a spring scale.
Brush spring force:
Standard
CVT model
12.3 - 16.7 N (1.25 - 1.70 kgf, 2.77 - 3.75 lbf) (when new)
MT model
15.9 - 19.5 N (1.62 - 1.99 kgf, 3.57 - 4.38 lbf) (when new)
Limit
CVT model
3.6 N (0.37 kgf, 0.81 lbf)
MT model
2.5 N (0.25 kgf, 0.56 lbf)