Auto Start Stop DC/DC CONVERTER 2
WARNING: This page is about a different variant/trim than selected.
- Install the Auto Start Stop DC/DC converter 2 to the bracket.
Tightening torque:
7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
- Install the Auto Start Stop DC/DC converter 1 and Auto Start Stop DC/DC converter 2 to the vehicle.
Tightening torque:
18 N.m (1.8 kgf-m, 13.3 ft-lb)
- Connect the connector to the Auto Start Stop DC/DC converter 1 and Auto Start Stop DC/DC converter 2, and install the clips.
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .