Inspection Mode 2
WARNING: This page is about a different variant/trim than selected.
| DTC | Description and trouble part | Note |
|---|---|---|
| B14A1 | SUNLOAD SENSOR CIRCUIT LOW/OPEN | - |
| B14A2 | SUNLOAD SENSOR CIRCUIT SHORT-CIRCUIT | - |
Diagnostic procedure:
- Using the Subaru Select Monitor, perform the clear memory of [Air Conditioner]. Ref. to COMMON (DIAG)>CLEAR MEMORY .
- Using the Subaru Select Monitor, read the DTC of [Air Conditioner] to check that there is no DTC displayed. Ref. to AIR CONDITIONER (DIAGNOSTICS) (EXCEPT FOR HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .NOTE: If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs. After solving the DTC, repeat from step 1.
- Park the vehicle in the place subjected to direct sunlight.
- Turn the ignition switch to ON and then leave it for 4 seconds or more.
- Using the Subaru Select Monitor, read the DTC of [Air Conditioner] to check that there is no DTC displayed. Ref. to AIR CONDITIONER (DIAGNOSTICS) (EXCEPT FOR HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .
NOTE:
If the DTC is displayed on the screen, the trouble is still present. Perform the diagnosis for the displayed DTCs.