DTC B14ED: Humidity Sensor Circuit Short

DTC detecting condition: 

Temperature and humidity sensor circuit is shorted.

Trouble symptom: 

Proper outlet air temperature cannot be kept during Auto Start Stop.

Wiring diagram: 

Air conditioning system Ref. to WIRING SYSTEM (CROSSTREK MODEL (EXCEPT FOR HEV))>AIR CONDITIONING SYSTEM>WIRING DIAGRAM .

Courtesy of SUBARU OF AMERICA, INC.

1. CHECK CONNECTOR  .
   1. Check connecting condition of the A/C control panel and the temperature and humidity sensor connector.
   2. Turn the ignition switch to ON.
   3. Read the DTC of [Air Conditioner] using the Subaru Select Monitor. Ref. to AIR CONDITIONER (DIAGNOSTICS) (EXCEPT FOR HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .

      Is DTC B14ED displayed? (Current malfunction)

      Yes:  Go to  2.

      No:  Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

      NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.
2. CHECK TEMPERATURE AND HUMIDITY SENSOR  .
   1. Turn the ignition switch to OFF.
   2. Disconnect the temperature and humidity sensor.
   3. Turn the ignition switch to ON.
   4. Read the DTC of [Air Conditioner] using the Subaru Select Monitor. Ref. to AIR CONDITIONER (DIAGNOSTICS) (EXCEPT FOR HEV)> DIAGNOSTIC TROUBLE CODE (DTC) .

      Is DTC B14EC displayed? (Current malfunction)

      Yes:  Replace the temperature and humidity sensor. Ref. to AIR CONDITIONER (EXCEPT FOR HEV)>TEMPERATURE AND HUMIDITY SENSOR .

      No:  Go to  3.

3. CHECK HARNESS  .

   Using a tester, measure the voltage between terminals in temperature and humidity sensor connector.

   Connector and terminal 

   (i55) No. 4 (+) - (i55) No. 2 (-):

   Is the voltage 4.5 - 5.5 V?

   Yes:  Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

   NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

   No:  Go to  4.

4. CHECK HARNESS (SHORTED BETWEEN LINES)  .
   1. Turn the ignition switch to OFF.
   2. Disconnect the connector from the A/C control panel.
   3. Using a tester, check the continuity between terminals in temperature and humidity sensor connector.

      Connector and terminal 

      (i55) No. 1 - (i55) No. 3:

      (i55) No. 1 - (i55) No. 4:

      (i55) No. 2 - (i55) No. 3:

      (i55) No. 2 - (i55) No. 4:

      (i55) No. 3 - (i55) No. 4:

      Is there continuity?

      Yes:  Repair or replace the short circuit of the harness.

      No:  Replace the A/C control panel. Ref. to AIR CONDITIONER (EXCEPT FOR HEV)>CONTROL PANEL .