DTC P1615: Starter Operation Number Of Times Excess: Notes
WARNING: This page is about a different variant/trim than selected.
1. -
DTC detecting condition:
Immediately at fault recognition
Trouble symptom:
Auto Start Stop does not operate.
CAUTION:
After servicing or replacing faulty parts, perform the last step of the basic diagnostic procedure. Ref. to AUTO START STOP (DIAGNOSTICS)>BASIC DIAGNOSTIC PROCEDURE .
- CHECK DATA MONITOR
.
- Turn the ignition switch to ON.
- Read the data of [Start Count] using Subaru Select Monitor. Ref. to AUTO START STOP (DIAGNOSTICS)>DATA MONITOR .
Is the value of [Start Count] 280000 Time or more?
Yes: Replace the starter and fuel pump relay at the same time. Ref. to STARTING/CHARGING SYSTEMS (H4DO (EXCEPT FOR HEV))>STARTER . Ref. to AUTO START STOP (DIAGNOSTICS)>ELECTRICAL COMPONENT LOCATION .
No: Replace the TCM. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580 CROSSTREK)>TRANSMISSION CONTROL MODULE (TCM) .