LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Crosstrek Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 25 (Engine Cooling System (Except For HEV)) >> Water Pipe >> Installation >> Heater Hose Pipe

Heater Hose Pipe

WARNING: This page is about a different variant/trim than selected.
  1. Connect the heater hose pipe to the water hose and heater inlet hose, and install the bolts securing the heater hose pipe.

    Tightening torque: 

    6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

  2. Install the air intake boot. Ref. to INTAKE (INDUCTION) (H4DO (EXCEPT FOR HEV))>AIR INTAKE BOOT>INSTALLATION .
  3. Install the front exhaust pipe. Ref. to EXHAUST (H4DO (EXCEPT FOR HEV))>FRONT EXHAUST PIPE>INSTALLATION .
  4. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  5. Fill engine coolant. Ref. to COOLING (H4DO (EXCEPT FOR HEV))>ENGINE COOLANT>REPLACEMENT>FILLING OF ENGINE COOLANT>2.5 L MODEL .
scientia non olet · About LEMON Manuals