Thermostat (Water Tank Pipe Side)
WARNING: This page is about a different variant/trim than selected.
- Install a new gasket to the thermostat.
- Install the thermostat and thermostat cover.NOTE: When installed, the air vent hole should face upward.
Tightening torque:
6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
- Connect the water hose.
- Install the EGR cooler. (2.5 L model) Ref. to EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES) (H4DO (EXCEPT FOR HEV))>EGR COOLER>INSTALLATION>2.5 L MODEL .
- Install the air intake boot. Ref. to INTAKE (INDUCTION) (H4DO (EXCEPT FOR HEV))>AIR INTAKE BOOT>INSTALLATION .
- Fill engine coolant.
2.0 L model: Ref. to COOLING (H4DO (EXCEPT FOR HEV))>ENGINE COOLANT>REPLACEMENT>FILLING OF ENGINE COOLANT>2.0 L MODEL .
2.5 L model: Ref. to COOLING (H4DO (EXCEPT FOR HEV))>ENGINE COOLANT>REPLACEMENT>FILLING OF ENGINE COOLANT>2.5 L MODEL .