Execution Condition
WARNING: This page is about a different variant/trim than selected.
| Secondary parameters | Execution condition |
|---|---|
| (1) - 1 Initial routine | ON |
| (1) - 2 Ignition switch | ON |
| (2) Ignition switch | ON |
| (3) Ignition switch | ON |
| (3) Battery voltage | 6.2V or more |
| (3) Electronic throttle control MOSFET | ON |
| (4) Ignition switch | ON |
| (5) Initial routine | ON |
| (6) Battery voltage | 6V or more |
| (6) CPU intentionally sends a motor cut-off command | ON |
| (7) ECM initialization | RUN |
| (8) Ignition switch | ON |
| (9) Time elapsed after engine start | 1 s or more |