DTC P05C0: Active Grille Air Shutter Module "A" Over Temperature: Notes
WARNING: This page is about a different variant/trim than selected.
- -
DTC detecting condition:
Immediately at fault recognition
NOTE: After the faulty parts are repaired or replaced, perform the final check in Basic Diagnostic Procedure. Ref. to ENGINE (DIAGNOSTICS) (H4DO 2.0 (EXCEPT FOR HEV))>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .
- CHECK DTC
.
- Turn the ignition switch to OFF, and cool down the engine enough.NOTE: Cool down the engine unit until it can be easily touched by hand.
- Turn the ignition switch to ON.
- Using the Subaru Select Monitor or a general scan tool, read the DTC of [Engine]. Ref. to COMMON (DIAG)>DIAGNOSTIC TROUBLE CODE (DTC) .
Is DTC P05C0 displayed? (Current malfunction)
Yes: Replace the active grille shutter. Ref. to COOLING (H4DO (EXCEPT FOR HEV))>ACTIVE GRILLE SHUTTER .
No: Even if DTC is detected, the circuit has returned to a normal condition at this time.
NOTE: In this case, there may have been a temporary rise of the temperature in the engine compartment. - Turn the ignition switch to OFF, and cool down the engine enough.