Execution Condition
WARNING: This page is about a different variant/trim than selected.
SECONDARY PARAMETERS AND EXECUTION CONDITION - DIAGNOSTIC METHOD 1
| Secondary parameters | Execution condition |
|---|---|
| Elapsed time after ignition switch is turned to ON | 500 ms or more and Less than 60000 ms |
| Soaking time | 60s or more |
| Evaporative Leak Check Module vacuum pump | Not in operation |
| Evaporative Leak Check Module switching valve | Open |
| Purge control | Not in operation |
SECONDARY PARAMETERS AND EXECUTION CONDITION - DIAGNOSTIC METHOD 2
| Secondary parameters | Execution condition |
|---|---|
| Elapsed time after Auto Start Stop control |
5000 ms or more |
| Purge control | Not in operation |