DTC P0088: Fuel Rail/System Pressure - Too High Bank 1: Notes

WARNING: This page is about a different variant/trim than selected.

-
DTC detecting condition:

Immediately at fault recognition

Trouble symptom:
- Poor driving performance
- Poor acceleration
NOTE: After the faulty parts are repaired or replaced, perform the final check in Basic Diagnostic Procedure. Ref. to ENGINE (DIAGNOSTICS) (H4DO 2.0 (EXCEPT FOR HEV))>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .

CHECK DTC .
Using the Subaru Select Monitor or a general scan tool, read the DTC of [Engine]. Ref. to COMMON (DIAG)>DIAGNOSTIC TROUBLE CODE (DTC) .

Is DTC other than P0088 displayed? (Current malfunction)

Yes: Check the appropriate DTC using the "Diagnostic Trouble Code (DTC)". Ref. to ENGINE (DIAGNOSTICS) (H4DO 2.0 (EXCEPT FOR HEV))>DIAGNOSTIC TROUBLE CODE (DTC) .

No: Go to 2.
CHECK FUEL PRESSURE .
1. Start the engine.
2. Using Subaru Select Monitor, read the value of [Fuel Rail Pressure A] and [Commanded Fuel Rail Pressure A] while the vehicle is accelerated from the parked state to 60 km/h (37.3 MPH) and stops again.
  CAUTION:
  - Follow traffic rules and give the highest priority to safe driving.
  - During driving, do not operate or gaze at the Subaru Select Monitor.
  - Always check the measurement value after bringing the vehicle to a stop in a safe place.
  NOTE:
  - In order to apply the running load to the vehicle, actually drive the vehicle, and read the measurement value.
  - For detailed operation procedures, refer to "Common (Diagnostics)". Ref. to COMMON (DIAG)>DATA MONITOR .
  Is the value of [Fuel Rail Pressure A] synchronized with that of [Commanded Fuel Rail Pressure A]?
  
  Yes: Replace the high-pressure fuel pump. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO (EXCEPT FOR HEV))>HIGH PRESSURE FUEL PUMP . After replacement, go to the next step.
  
  Go to 3.
  
  No: Replace the fuel pressure sensor. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO (EXCEPT FOR HEV))>FUEL PRESSURE SENSOR .
CHECK FOR REPRODUCTION OF FAILURE .
1. Using the Subaru Select Monitor or a general scan tool, perform the clear memory of [Engine]. Ref. to COMMON (DIAG)>CLEAR MEMORY .
2. Perform the corresponding inspection mode. Ref. to ENGINE (DIAGNOSTICS) (H4DO 2.0 (EXCEPT FOR HEV))>INSPECTION MODE .
3. Using the Subaru Select Monitor or a general scan tool, read the DTC of [Engine]. Ref. to COMMON (DIAG)>DIAGNOSTIC TROUBLE CODE (DTC) .
  Is DTC P0088 displayed? (Current malfunction)
  
  Yes: Repair the poor contact of ECM connector.
  
  No: End.