DTC P0030: A/F/O2 Heater Control Circuit Bank 1 Sensor 1: Notes

WARNING: This page is about a different variant/trim than selected.

-
DTC detecting condition:

Detected when two consecutive driving cycles with fault occur.

Wiring diagram:

Engine Electrical System Ref. to WIRING SYSTEM (IMPREZA MODEL)>ENGINE ELECTRICAL SYSTEM>WIRING DIAGRAM . Ref. to WIRING SYSTEM (CROSSTREK MODEL (EXCEPT FOR HEV))>ENGINE ELECTRICAL SYSTEM>WIRING DIAGRAM .
- IMPREZA MODEL
Courtesy of SUBARU OF AMERICA, INC.
- CROSSTREK MODEL
Courtesy of SUBARU OF AMERICA, INC.

CAUTION: Use the check board when measuring the ECM terminal voltage and resistance. Ref. to ENGINE (DIAGNOSTICS) (H4DO 2.0 (EXCEPT FOR HEV))>GENERAL DESCRIPTION>PREPARATION TOOL>HOW TO USE CHECK BOARD .

NOTE: After the faulty parts are repaired or replaced, perform the final check in Basic Diagnostic Procedure. Ref. to ENGINE (DIAGNOSTICS) (H4DO 2.0 (EXCEPT FOR HEV))>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .

CHECK HARNESS BETWEEN ECM AND FRONT OXYGEN (A/F) SENSOR CONNECTOR (OPEN) .
1. Start and warm up the engine.
2. Turn the ignition switch to OFF.
3. Disconnect the connector from ECM.
4. Disconnect the connector from the front oxygen (A/F) sensor.
5. Measure the resistance of harness between ECM connector and front oxygen (A/F) sensor connector.
  Connector and terminal
  
  (E158) No. 88 - (B379) No. 1:
  
  (E158) No. 3 - (B379) No. 3:
  
  (E158) No. 4 - (B379) No. 4:
  
  Is the resistance less than 1 Ω?
  
  Yes: Go to 2.
  
  No: Repair the open circuit of harness between ECM connector and front oxygen (A/F) sensor connector.
CHECK FRONT OXYGEN (A/F) SENSOR .
Check the front oxygen (A/F) sensor. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO (EXCEPT FOR HEV))>FRONT OXYGEN (A/F) SENSOR>INSPECTION .

Is the check result OK?

Yes: Go to 3.

No: Replace the front oxygen (A/F) sensor. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO (EXCEPT FOR HEV))>FRONT OXYGEN (A/F) SENSOR .
CHECK FOR POOR CONTACT .
Check for poor contact of ECM and front oxygen (A/F) sensor connector.

Is there poor contact of ECM or front oxygen (A/F) sensor connector?

Yes: Repair the poor contact of ECM or front oxygen (A/F) sensor connector.

No: Replace the front oxygen (A/F) sensor. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO (EXCEPT FOR HEV))>FRONT OXYGEN (A/F) SENSOR .