LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Crosstrek Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Control System (2.5L) (Diagnostics) (2 Of 4)) >> Diagnostic Procedure With Diagnostic Trouble Code (DTC) >> DTC P0401: EGR Abnormal (EGR Amount Too Small) >> Notes

DTC P0401: EGR Abnormal (EGR Amount Too Small): Notes

WARNING: This page is about a different variant/trim than selected.

1. - 

DTC detecting condition: 

Detected when two consecutive driving cycles with fault occur.

Trouble symptom: 

NOTE: After the faulty parts are repaired or replaced, perform the final check in Basic Diagnostic Procedure. Ref. to ENGINE (DIAGNOSTICS) (H4DO 2.5)>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .
  1. CHECK DTC  .
    1. Turn the ignition switch to ON.
    2. Using the Subaru Select Monitor or a general scan tool, read the DTC of [Engine]. Ref. to COMMON (DIAG)>DIAGNOSTIC TROUBLE CODE (DTC) .

    Are DTCs other than P0401 and P0402 displayed? (Current malfunction)

    Yes:  Check the appropriate DTC using the "Diagnostic Trouble Code (DTC)". Ref. to ENGINE (DIAGNOSTICS) (H4DO 2.5)>DIAGNOSTIC TROUBLE CODE (DTC) .

    No: 

    • DTC P0401 displayed: Go to  2.
    • DTC P0402 displayed: Go to  3.
  2. CHECK DTC P0401  .
    1. Turn the ignition switch to OFF.
    2. Check for clogging in the pipes consisting of the EGR system.
    NOTE: Check the following items.
    • Throttle valve
    • EGR cooler
    • EGR control valve
    • EGR pipe
    • EGR pipe adapter

    Is the check result OK?

    Yes:  Go to  4.

    No:  Clean and replace the faulty parts.

  3. CHECK DTC P0402  .
    1. Turn the ignition switch to OFF.
    2. Check for leakage in the pipes consisting of the EGR system.
    NOTE: Check the following items.
    • Looseness of each flange connection
    • Improper installation of throttle body
    • Improper installation of manifold absolute pressure sensor
    • Foreign matter attached to EGR valve

    Is the check result OK?

    Yes:  Go to  4.

    No:  Clean and replace the faulty parts.

  4. CHECK FOR REPRODUCTION OF FAILURE  .

    Perform the corresponding inspection mode. Ref. to ENGINE (DIAGNOSTICS) (H4DO 2.5)>INSPECTION MODE .

    Does the malfunction indicator light illuminate?

    Yes:  Replace the EGR control valve and manifold absolute pressure sensor. Ref. to EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES) (H4DO (EXCEPT FOR HEV))>EGR CONTROL VALVE . Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO (EXCEPT FOR HEV))>MANIFOLD ABSOLUTE PRESSURE SENSOR .

    No:  End.