Heater Duct: Removal: Front
WARNING: This page is about a different variant/trim than selected.
- Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY
.NOTE:
- For CVT models, release the shift lock and shift the select lever to the "N" position.
- For the power seat model, remove the console box before removing the ground terminal from the battery sensor.
- Remove the cover assembly - front and the console box assembly, Ref. to EXTERIOR/INTERIOR TRIM>CONSOLE BOX>REMOVAL .
- Remove the cover assembly - instrument panel LWR driver INN. (When removing LH side) Ref. to EXTERIOR/INTERIOR TRIM> INSTRUMENT PANEL LOWER COVER>REMOVAL .
- Remove the pocket assembly and the back panel - pocket. (When removing RH side) Ref. to EXTERIOR/INTERIOR TRIM>GLOVE BOX>REMOVAL .
- Remove the duct - rear heater front.