LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Crosstrek Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (HVAC System (Heater, Ventilator And A/C) (Except For HEV)) >> Expansion Valve >> Installation

Expansion Valve: Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • Since the auto A/C model uses the variable displacement compressor, be careful of the following items.
    • Do not start the engine before charging refrigerant.
    • If the engine is started with no refrigerant charge, replace the compressor assembly.
  • Replace the O-rings with new parts, and then apply compressor oil to install completely.
  1. Install the expansion valve - cooling.

    Preparation tool: 

    Hexagon wrench: 4 mm (0.16 in)

    Tightening torque: 

    3.5 N.m (0.4 kgf-m, 2.6 ft-lb)

  2. Install the hose - pressure suction, Ref. to AIR CONDITIONER (EXCEPT FOR HEV)>HOSE AND PIPE>INSTALLATION>LOW-PRESSURE HOSE .
  3. Install the air intake boot. Ref. to INTAKE (INDUCTION) (H4DO (EXCEPT FOR HEV))>AIR INTAKE BOOT>INSTALLATION .
  4. Charge refrigerant, Ref. to AIR CONDITIONER (EXCEPT FOR HEV)>REFRIGERANT CHARGING PROCEDURE>PROCEDURE .
scientia non olet · About LEMON Manuals