LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Crosstrek Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (HVAC System (Heater, Ventilator And A/C) (Except For HEV)) >> Air Mix Door Actuator >> Removal >> Passenger's Side

Passenger's Side

WARNING: This page is about a different variant/trim than selected.
CAUTION: If reusing the motor - actuator mix, perform the following procedures to prevent incorrect installation.
  1. While the part is installed to the vehicle, turn the temperature control dial to the MAX COOL position.
  2. Wait for 30 seconds in the condition 1, and remove the motor - actuator mix.
    1. Disconnect the ground terminal from battery sensor, Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
    2. Remove the pocket assembly and the back panel - pocket. Ref. to EXTERIOR/INTERIOR TRIM .
    3. Remove the motor - actuator mix.
      1. Disconnect the connector.
      2. Remove the screws and detach the motor - actuator mix.
G11245715Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals