LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Crosstrek Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Emission Control Systems (Aux. Emission Control Devices) (Except For HEV)) >> Purge Control Solenoid Valve >> Removal >> 2.0 L Model

2.0 L Model

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the clip from the air intake boot, and loosen the clamp.
    G11252776Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the air intake boot, and place it aside so that it does not interfere with the work.
    CAUTION: Be careful not to pull out the PCV hose.
    G11252777Courtesy of SUBARU OF AMERICA, INC.
  4. Disconnect the connector (A), and disconnect the clip (B) which secures the engine wiring harness from the purge control solenoid valve bracket.
  5. Disconnect the evaporation hose (C).
  6. Disconnect the vacuum hose (D) from the intake manifold assembly, and remove the vacuum hose (D) from the clip (E).
  7. Remove the bolt securing the purge control solenoid valve, and remove the purge control solenoid valve.
    G11253034Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the purge control solenoid valve bracket.
    G11253035Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the vacuum hose from the purge control solenoid valve.
scientia non olet · About LEMON Manuals