LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Crosstrek Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (CVT Transaxle (Tr580 CROSSTREK)) >> Extension Case Oil Seal >> Replacement

Extension Case Oil Seal: Replacement

WARNING: This page is about a different variant/trim than selected.
  1. Release the parking brake.
  2. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  3. Release the shift lock using a screwdriver, etc. and shift the select lever to the "N range".
    G13233130Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the propeller shaft. Ref. to DRIVE SHAFT SYSTEM>PROPELLER SHAFT>REMOVAL .
  5. Remove the front exhaust pipe. Ref. to EXHAUST (H4DO (EXCEPT FOR HEV))>FRONT EXHAUST PIPE>REMOVAL .
  6. Remove the extension case oil seal using a flat tip screwdriver wrapped with protection tape, etc.
    G13592011Courtesy of SUBARU OF AMERICA, INC.
  7. Using the ST, install a new extension case oil seal.
    NOTE:

    Apply CVTF to the oil seal lip and peripheral surface. 

    Preparation tool: 

    ST: INSTALLER (498057300)

    G13225669Courtesy of SUBARU OF AMERICA, INC.
  8. Install the front exhaust pipe. Ref. to EXHAUST (H4DO (EXCEPT FOR HEV))>FRONT EXHAUST PIPE>INSTALLATION .
  9. Install the propeller shaft. Ref. to DRIVE SHAFT SYSTEM>PROPELLER SHAFT>INSTALLATION .
  10. Shift the select lever to "P range".
  11. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  12. Apply the parking brake.
  13. Check the CVTF level. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580 CROSSTREK)>CVTF>INSPECTION .
scientia non olet · About LEMON Manuals