Control Valve Body: Inspection
WARNING: This page is about a different variant/trim than selected.
- Check for oil leaks.
- Check that there is no deformation, cracks or other damages.
- Measure the resistance of each solenoid, sensor and ground wire.
NOTE:
Measurement should be performed at 20°C (68°F).
| Terminal No. | Standard | |
|---|---|---|
| Line pressure solenoid | 1 - Control valve body | 3.3 - 7.3 Ω |
| Lock-up duty solenoid | 2 - Control valve body | 10 - 14.2 Ω |
| F & R clutch solenoid | 3 - Control valve body | 3.3 - 7.3 Ω |
| Secondary solenoid | 4 - Control valve body | 3.3 - 7.3 Ω |
| Oil pump ON/OFF solenoid | 6 - Control valve body | 12.5 - 19.5 Ω |
| Primary DOWN solenoid | 7 - Control valve body | 10 - 14.2 Ω |
| Primary UP solenoid | 8 - Control valve body | 10 - 14.2 Ω |
| AWD solenoid | 9 - Control valve body | 3.3 - 7.3 Ω |
| Oil temperature sensor | 5 - 10 | Approx. 2.5 kΩ [20°C (68°F)] |