LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Crosstrek Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Manual Transaxle & Differential (6MT)) >> Transmission Mounting System >> Removal >> CROSSMEMBER And Cushion Rubber

CROSSMEMBER And Cushion Rubber

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  2. Lift up the vehicle.
  3. Remove the crossmember support - rear.
    G11256105Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the front exhaust pipe. Ref. to EXHAUST (H4DO (EXCEPT FOR HEV))>FRONT EXHAUST PIPE>REMOVAL .
  5. Remove the center exhaust cover.
    G11254834Courtesy of SUBARU OF AMERICA, INC.
  6. Set the transmission jack.
    CAUTION: Always support the transmission case with a transmission jack.
    G09482515Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the front crossmember and the rear crossmember.
    G11256143Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the transmission cushion rubber.
scientia non olet · About LEMON Manuals