Transfer Driven Gear: Assembly

WARNING: This page is about a different variant/trim than selected.

Using the ST, install the taper roller bearing (transfer case side).
CAUTION:
- Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).
- Be careful when handling, because the outer race and inner race of the taper roller bearing are used as a set.
Preparation tool: ST: INSTALLER (927640000)

Courtesy of SUBARU OF AMERICA, INC.
Using the ST1 and ST2, install the taper roller bearing (extension case side).
CAUTION:
- Do not apply a load in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton).
- Be careful when handling, because the outer race and inner race of the taper roller bearing are used as a set.
Preparation tool: ST1: INSTALLER (498175500)

ST2: REMOVER (899864100)

Courtesy of SUBARU OF AMERICA, INC.