LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Crosstrek Hybrid >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Manual Transaxle & Differential (6MT)) >> Transfer Drive Gear >> Installation

Transfer Drive Gear: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the transfer drive gear.

    Tightening torque:  26 N.m (2.7 kgf-m, 19.2 ft-lb)

    G08581974Courtesy of SUBARU OF AMERICA, INC.
  2. Install the transfer driven gear. Ref. to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT)>TRANSFER DRIVEN GEAR>INSTALLATION .
  3. Select the adjusting washer. Ref. to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT)>TRANSFER CASE AND EXTENSION CASE ASSEMBLY>INSTALLATION .
  4. Install the transfer case and the extension case assembly. Ref. to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT)>TRANSFER CASE AND EXTENSION CASE ASSEMBLY>INSTALLATION .
  5. Install the back-up light switch and the neutral position switch. Ref. to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT)>SWITCHES AND HARNESS>INSTALLATION .
  6. Install the manual transmission assembly to the vehicle. Ref. to MANUAL TRANSMISSION AND DIFFERENTIAL (6MT)>MANUAL TRANSMISSION ASSEMBLY>INSTALLATION .
scientia non olet · About LEMON Manuals