Differential Case Assembly

WARNING: This page is about a different variant/trim than selected.

Loosen the twelve bolts and remove hypoid driven gear.

Courtesy of SUBARU OF AMERICA, INC.
Using the ST, drive out the straight pin from differential assembly toward hypoid driven gear side.
Preparation tool: ST: STRAIGHT PIN REMOVER (899904100)

Courtesy of SUBARU OF AMERICA, INC.
Pull out the pinion shaft, and remove the differential bevel pinion, differential bevel gear and adjusting washer.

Courtesy of SUBARU OF AMERICA, INC.
Using the ST, remove the taper roller bearing.
Preparation tool: ST: PULLER SET (899524100)

Courtesy of SUBARU OF AMERICA, INC.