Traffic Jam Assist/Lane Keeping Assist Deactive Code(s) Display: Operation

WARNING: This page is about a different variant/trim than selected.

Check the traffic jam assist/lane keep assist deactivation code: When the lane keep assist • adaptive cruise steering does not operate with the lane keep assist • adaptive cruise steering standby condition (lane keep assist • adaptive cruise steering main ON condition), the traffic jam assist/lane keep assist deactivation code is output.

NOTE: When the condition that the lane keep assist • adaptive cruise steering does not operate while the vehicle is driven straight at 10 km/h or more continues for 30 seconds, the reason is recorded.

On [Start] screen, select [Diagnosis].
On [Vehicle selection] screen, input the target vehicle information and select [OK].
On [Main Menu] screen, select [Each System].
On [Select System] screen, select [EyeSight], and then select [Enter].
On [Select Function] screen, select [Cancel Code].
On [Cancel Code] screen, select [Traffic Jam Assist/Lane Keeping Assist Deactive Code(s) Display].
NOTE:
- For detailed operation procedures, refer to "Help" of application.
- Up to 8 codes can be stored. When nine codes or more are output, the oldest code will be deleted to store the latest code.
- Stored codes will be cleared by Clear Memory. Ref. to COMMON (DIAG)>CLEAR MEMORY .
- For the details of the traffic jam assist/lane keep assist deactivation code, refer to the list of the traffic jam assist/lane keep assist deactivation codes. Ref. to EYESIGHT (DIAGNOSTICS) (EXCEPT FOR HEV)>TRAFFIC JAM ASSIST/LANE KEEPING ASSIST DEACTIVE CODE(S) DISPLAY>LIST .