Lane Departure Prevention Assist Deactivate Code(s) Display: Operation

WARNING: This page is about a different variant/trim than selected.

Lane Departure Prevention Deactivate Code(s) Display: The lane departure prevention deactivate code is output, when the lane keep (lane departure prevention) is canceled during the operation or the standby state is canceled.

On [Start] screen, select [Diagnosis].
On [Vehicle selection] screen, input the target vehicle information and select [OK].
On [Main Menu] screen, select [Each System].
On [Select System] screen, select [EyeSight], and then select [Enter].
On [Select Function] screen, select [Cancel Code].
On [Cancel Code] screen, select [Lane Departure Prevention Assist Deactivate Code(s) Display].
NOTE:
- For detailed operation procedures, refer to "Help" of application.
- Up to 8 codes can be stored. When eight codes or more are output, the oldest code will be deleted to store the latest code.
- Stored codes will be cleared by Clear Memory. Ref. to COMMON (DIAG)>CLEAR MEMORY .
- For detailed lane departure prevention deactivate code, refer to the lane departure prevention deactivate code list. Ref. to EYESIGHT (DIAGNOSTICS) (EXCEPT FOR HEV)>LANE DEPARTURE PREVENTION ASSIST DEACTIVATE CODE(S) DISPLAY>LIST .