EyeSight HALT Code: Operation

If the EyeSight pause code is detected from the stereo camera, all the functions of the EyeSight excluding the conventional cruise control stop temporarily and cannot be used. When the failure is resolved, the function starts operating.

1. On [Start] display, select [Diagnosis].
2. On [Vehicle selection] display, input the target vehicle information and select [OK].
3. On [Main Menu] display, select [Each System].
4. On [Select System] display, select [EyeSight], and then select [Enter].
5. On [Select Function] display, select [Cancel Code].
6. On [Cancel Code] display, select [EyeSight HALT Code].
   NOTE:

   • For detailed operation procedures, refer to "Help" of application.
   • Temporary stop is not released even if the lane departure warning OFF switch or pre-collision brake OFF switch is pressed.
   • Depending on the situation, temporary stop may not be released even if the ignition switch is turned off.
   • Up to 20 codes can be stored.
   • Stored codes will be cleared by Clear Memory. Ref. to COMMON (DIAG)>CLEAR MEMORY .
   • For details on EyeSight temporary stop codes, refer to List of EyeSight temporary stop code. Ref. to EYESIGHT (DIAGNOSTICS) (EXCEPT FOR HEV)>EYESIGHT HALT CODE>LIST .