Check List (Camera Temporary Stop)
WARNING: This page is about a different variant/trim than selected.
Even when the set status of the adaptive cruise control is canceled or when a temporary stop status occurs, the EyeSight temporary stop code will not be retained for the following conditions.
- When the VDC operation is stopped by pressing the VDC OFF switch
- When the pre-collision brake operation is stopped by pressing the pre-collision brake OFF switch
- When the lane departure warning is stopped by pressing the lane departure warning OFF switch
- Immediately after the engine start
When these cases does not apply but the EyeSight temporary stop code is displayed, perform the inspection according to the following items.
| Item name | Yes/No | |||
|---|---|---|---|---|
| [1]: EyeSight temporary stop code [CC, CD] (At this time, "Temporary stop Camera view defectiveness" is displayed in the multi-information display.) | ||||
| 1 | Check that the current status applies to the condition that are difficult to be recognized by the stereo camera. | |||
| 1 | It was bad weather (heavy rain, snowstorm, dense fog; especially when the oil film adheres to the windshield glass, the glass coating agent is used, or when the old wiper is used). | Yes | No | |
| 2 | The vehicle was exposed to the intense light (backlight such as sunlight or headlight high-beam light) from the front of the vehicle. | Yes | No | |
| 3 | The raindrops, water drops or dirt on the windshield glass are not wiped off sufficiently. | Yes | No | |
| 4 | The windshield glass is covered with fog, snow, dirt, frost or sandy dust, and either of them blocks the visibility of the stereo camera. | Yes | No | |
| 5 | The vehicle was tilted excessively by the heavy load. | Yes | No | |
| 6 | Canoes etc. loaded on the roof blocked the visibility of the stereo camera. | Yes | No | |
| 7 | The field of view was insufficient due to water or snow raised by the preceding vehicle or oncoming vehicle, or the moisture, sand, smoke or sandy dust blown in the wind. | Yes | No | |
| 8 | The vehicle passed through the outlet or inlet of a tunnel. | Yes | No | |
| 9 | The rearmost area of preceding vehicle was small (trailer, etc.), low or uneven. | Yes | No | |
| 10 | The object was a fence or wall with even pattern (striped pattern or bricks) or unpatterned surface. | Yes | No | |
| 11 | The object was a plate of glass, mirror wall or door. | Yes | No | |
| 12 | The tail light of the preceding vehicle did not illuminate during nighttime hours or inside the tunnel. | Yes | No | |
| 13 | The vehicle passed through the banners, flags, drooping branches or grass. | Yes | No | |
| 14 | The vehicle drove on the steep uphills or steep downhills. | Yes | No | |
| 15 | Front of the camera was blocked by the hand. | Yes | No | |
| 16 | It was very dark and there was no obstacle around the vehicle. | Yes | No | |
| 17 | The surrounding ground surface was similarly colored. (There is snow as far as the eye can see.) | Yes | No | |
| 18 | Dirt such as fingerprint adhered to the lens portion of the stereo camera. | Yes | No | |
| 19 | Stable recognition was difficult because of reflection to the windshield glass. | Yes | No | |
| 20 | The stereo camera was subject to impact, and the displacement or distortion occurred. | Yes | No | |
| [2]: EyeSight temporary stop code [CE] (At this time, "Temporary stop Camera temperature range outside" is displayed in the multi-information display.) | ||||
| 1 | Check that the current status applies to the condition that the temperature of the stereo camera becomes excessively high or low. | |||
| 1 | The compartment temperature was high. (For example: The vehicle was left under the scorching sun.) Or the compartment temperature was low. (For example: The vehicle was left under the frigid environment.) | Yes | No | |
| [3]: EyeSight temporary stop code [E5] (At this time, "Temporary stop" is displayed in the multi-information display.) | ||||
| 1 | Check that the current status applies to the condition that the vertical deviation occurs on the stereo camera optical axis. | |||
| 1 | The vehicle was tilted excessively by the heavy load. | Yes | No | |
| 2 | The vehicle drove on the steep uphills or steep downhills. | Yes | No | |
| 3 | The stereo camera was subject to impact, and the displacement or distortion occurred. | Yes | No | |
| [4]: EyeSight temporary stop code [33] (At this time, "Temporary stop" is displayed in the multi-information display.) | ||||
| 1 | Check that the current status applies to the condition that the engine speed drops to 300 rpm or below. | Yes | No | |
| [5]: EyeSight temporary stop code [CO] (At this time, "Temporary stop" is displayed in the multi-information display.) | ||||
| 1 | Check that the current status applies to the condition that the pre-collision secondary brake operated three times between starting and stopping of engine. | Yes | No | |
| [6]: EyeSight temporary stop code [AO] (At this time, "Temporary stop" is displayed in the multi-information display.) | ||||
| 1 | Check that the current status applies to the condition that the voltage dropped below 10 V immediately after the ignition ON. | Yes | No | |
| [7]: EyeSight temporary stop code [A1] (At this time, "Temporary stop" is displayed in the multi-information display.) | ||||
| 1 | Check that the control module (CM) is currently being reprogrammed. | Yes | No | |
| [8]: EyeSight temporary stop code [F9] (At this time, "Temporary stop" is displayed in the multi-information display.) | ||||
| 1 | Check that the current status applies to the condition that the steering wheel is operated repeatedly when the vehicle stops or moves very slowly. | Yes | No | |
| [9]: EyeSight temporary stop code [FA] (At this time, "Temporary stop" is displayed in the multi-information display.) | ||||
| 1 | Check that this is applied to the condition that the wheel alignment is extremely misaligned. | Yes | No | |
| 2 | Check that this is applied to the condition that the center point of the steering angle sensor is misaligned. | Yes | No | |