At Rapid Start Prevention Control Does Not Operate/At Rapid Start Prevention Control Is Released Automatically

WARNING: This page is about a different variant/trim than selected.

CHECK PRE-COLLISION BRAKE OFF INDICATOR LIGHT .
Check the pre-collision brake OFF indicator light.

Is the pre-collision brake OFF indicator light off?

Yes: Go to 2.

No: This is normal. Operate the brake OFF switch to deactivate. When the indicator remains on after the deactivation, perform the diagnosis described in "Pre-collision brake OFF indicator light does not go off".
CHECK USING CHECK LIST .
Using CHECK LIST (AT RAPID START PREVENTION CONTROL), check the following and respond to it.
- Does it apply to the condition that the AT rapid start prevention control may not operate?
- Does it apply to the condition that the pre-collision brake OFF indicator light illuminates?
Is there a relevant item in the check list?

Yes: When there is a relevant item, it can be the cause of malfunction. Eliminate the cause, and check that the malfunction has been improved.

No: Replace the stereo camera. Ref. to EYESIGHT>STEREO CAMERA>REMOVAL .