DTC B28A5: Engine Torque Limiter Control Prohibit

WARNING: This page is about a different variant/trim than selected.

Detected when abnormal data is transmitted from stereo camera to engine control module (ECM) and the engine control module (ECM) prohibits the AT rapid start prevention control, or when the engine control module (ECM) prohibits the AT rapid start prevention control.

DTC detecting condition:

Defective CAN system
Defective engine control module (ECM)
Defective stereo camera
Defective combination meter
Incorrect assembly of combination meter (when the combination meter that is not for EyeSight is installed.)

Trouble symptom:

All functions of EyeSight system do not operate.
EyeSight warning light illuminates.

CAUTION: Before performing diagnosis, refer to "CAUTION" in "General Description" Ref. to EYESIGHT (DIAGNOSTICS) (EXCEPT FOR HEV)>GENERAL DESCRIPTION>CAUTION .

CHECK COMBINATION METER .
Check the part number of the combination meter.

Is the combination meter genuine?

Yes: Go to 2.

No: Replace the combination meter Ref. to INSTRUMENTATION/DRIVER INFO>COMBINATION METER .
CHECK LAN SYSTEM .
Perform the diagnosis for LAN system. Ref. to LAN SYSTEM (DIAGNOSTICS) (EXCEPT FOR HEV)>BASIC DIAGNOSTIC PROCEDURE .

Is the check result OK?

Yes: Go to 3.

No: Perform the diagnosis for LAN system.
CHECK ECM .
Perform the diagnosis for the engine. Ref. to ENGINE (DIAGNOSTICS) (H4DO 2.0 (EXCEPT FOR HEV))>BASIC DIAGNOSTIC PROCEDURE>PROCEDURE .

Is the check result OK?

Yes: Go to 4.

No: Perform the diagnosis for the engine.
CHECK CONNECTOR .
Check the ECM connector and the stereo camera connector.

Is the check result OK?

Yes: Go to 5.

No: Repair or replace the connector.
CHECK STEREO CAMERA .
1. Turn the ignition switch to ON.
2. Read the DTC of [EyeSight] using the Subaru Select Monitor Ref. to EYESIGHT (DIAGNOSTICS) (EXCEPT FOR HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .
Is DTC other than DTC B28A5 displayed?

Yes: Perform the diagnosis for DTC other than DTC B28A5.

No: Go to 6.
CHECK STEREO CAMERA .
1. Using the Subaru Select Monitor, perform the clear memory of [EyeSight] Ref. to COMMON (DIAG)>CLEAR MEMORY .
2. Read the DTC of [EyeSight] using the Subaru Select Monitor. Ref. to EYESIGHT (DIAGNOSTICS) (EXCEPT FOR HEV)>DIAGNOSTIC TROUBLE CODE (DTC) .
Is DTC B28A5 displayed?

Yes: Replace the stereo camera. Ref. to EYESIGHT>STEREO CAMERA>REMOVAL .

No: Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.