DTC B2822: TCM Data Abnormal

WARNING: This page is about a different variant/trim than selected.

DTC detecting condition:

Detected when there are no AT turbine speed inputs during driving and the TCM module is determined as abnormal. Detected when all of the following conditions are met:

Drive wheels' average wheel speed is 15 km/h or more.
Engine speed is 1000 rpm or more.
Turbine speed is 0 or less.

Trouble symptom:

Standing start problems
All functions of EyeSight system do not operate.
EyeSight warning light blinks or illuminates.

CAUTION: Before performing diagnosis, refer to "CAUTION" in "General Description". Ref. to EYESIGHT (DIAGNOSTICS) (EXCEPT FOR HEV)>GENERAL DESCRIPTION>CAUTION .

CHECK DTC .
1. Turn the ignition switch to ON.
2. Read the DTC of [Transmission] using the Subaru Select Monitor. Ref. to TRANSMISSION (DIAGNOSTICS) (IMPREZA MODEL)>DIAGNOSTIC TROUBLE CODE (DTC) .
Are any DTCs displayed?

Yes: Perform the diagnosis for the displayed DTCs. Ref. to TRANSMISSION (DIAGNOSTICS) (IMPREZA MODEL)>DIAGNOSTIC TROUBLE CODE (DTC)>LIST .

No: Perform the diagnosis for LAN system. Ref. to LAN SYSTEM (DIAGNOSTICS) (EXCEPT FOR HEV)>BASIC DIAGNOSTIC PROCEDURE .