Execution Condition
WARNING: This page is about a different car, the 2021 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
| Secondary parameters | Execution condition |
|---|---|
| Diagnosis 1 12 V battery system voltage (The timer is held when the following conditions are not satisfied.) |
10 V or more |
| Transmission range | Drive |
| Vehicle speed (calculated from secondary pulley shaft speed) | 21.7 MPH or more |
| Diagnosis 2 12 V battery system voltage |
10 V or more |
| Soak time (received from ECM) | 21600 s or more |
| (Engine speed | 400 rpm or more |
| for time)
NOTE:
The monitor detects TFT sensor stuck high after the elapse of 300 seconds required for ECT sensor diagnosis. It is necessary to avoid misdiagnosis of P0711 caused by a malfunctioning ECT sensor.
|
300 s or more |