Turbine Speed Sensor: Installation
WARNING: This page is about a different car, the 2021 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Be sure to prevent water or oil from contacting the connector terminal of turbine speed sensor. If adhesion occurs, replace with a new part.
- Install the turbine speed sensor.NOTE:
- Use new O-rings.
- Apply CVTF to the O-rings.
Tightening torque: 7 N.m (0.7 kgf-m, 5.2 ft-lb)
- Connect the harness connector.
- Lower the vehicle.
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .