LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Crosstrek Hybrid >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (CVT Transaxle (Tr580 IMPREZA)) >> Secondary Speed Sensor >> Installation

Secondary Speed Sensor: Installation

WARNING: This page is about a different car, the 2021 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Be sure to prevent water or oil from contacting the connector terminal of secondary speed sensor. If adhesion occurs, replace with a new part.
  • After installing the secondary speed sensor, adjust the CVTF level.
  1. Install the secondary speed sensor and spacer.
    NOTE:
    • Use new O-rings.
    • Apply CVTF to the O-rings.

    Tightening torque:  7 N.m (0.7 kgf-m, 5.2 ft-lb)

  2. Connect the harness connector.
  3. Lower the vehicle.
  4. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  5. Refill CVTF to adjust the CVTF level. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580 IMPREZA)>CVTF .
scientia non olet · About LEMON Manuals