Secondary Pressure Sensor: Installation

WARNING: This page is about a different car, the 2021 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Be sure to prevent water or oil from contacting the connector terminal of secondary pressure sensor. If adhesion occurs, replace with a new part.
After installing the secondary pressure sensor, adjust the CVTF level.

Install in the reverse order of removal.

NOTE: Use new O-rings.

Tightening torque: 39 N.m (4.0 kgf-m, 28.8 ft-lb)