LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Crosstrek Hybrid >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (CVT Transaxle (Tr580 IMPREZA)) >> Inhibitor Switch >> Removal

Inhibitor Switch: Removal

WARNING: This page is about a different car, the 2021 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
  2. Shift the select lever to the "N" range.
  3. Lift up the vehicle.
  4. Remove the front exhaust pipe. Ref. to EXHAUST (H4DO (EXCEPT FOR HEV))>FRONT EXHAUST PIPE>REMOVAL .
  5. Remove the snap pin and washer from the shifter arm.
    CAUTION: Do not apply excessive load while holding the part (a).
    G13591814Courtesy of SUBARU OF AMERICA, INC.
    G13936588Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the spring pin and shifter arm.
    G13936589Courtesy of SUBARU OF AMERICA, INC.
  7. Disconnect the inhibitor harness connector.
  8. Remove the inhibitor switch.
    G11255610Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals