LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Crosstrek Hybrid >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (CVT Transaxle (Tr580 IMPREZA)) >> General Description >> Preparation Tool >> General Tool

General Tool

WARNING: This page is about a different car, the 2021 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.
TOOL NAME REMARKS
Circuit tester Used for measuring resistance, voltage and current.
Thickness gauge Used for measuring the clearance in reverse brake, forward clutch and transfer clutch.
Caliper Used for measuring the dimension.
Spring scale Used for measuring the starting torque of the drive pinion.
TORX® bit T40 Used for removing the secondary pressure (line pressure) test plug.
TORX® bit T70 Used for removing and installing differential gear oil drain plug.
Straight pin remover Used for removing and installing the straight pin and spring pin.
Push/pull gauge Used for measuring clutch clearance.
Angle gauge Used for installing the drive plate.
Dial gauge
  • Used for measuring backlash. (Lever type)
  • Used together with magnet stand.
  • Used for assembling the reverse brake and forward clutch. (Spindle type)
  • Used together with magnet stand.
Magnet stand
  • Used for measuring backlash.
  • Used together with the dial gauge (lever type).
  • Used for assembling the reverse brake and forward clutch.
  • Used together with the dial gauge (spindle type).
DST-i Used together with Subaru Select Monitor 4.
scientia non olet · About LEMON Manuals